Self-Assembly 4mm Balustrade Kit (For Steel or Timber)

  • Self-Assembly 4mm Balustrade Kit (For Steel or Timber)

Self-Assembly 4mm Balustrade Kit (For Steel or Timber)


  • Product Code: BALU0020
  • Availability: 228
  • £17.90 Each


Kit Includes:

2 x Threaded Terminals with Nuts, Curved Washers and Flat Washers

2 x Hex Head Tensioners with Curved Washers and Flat Washers



Recommended Tools:

Drill, Wire Cutters and Spanners.


Assembly Instructions:


SAFETY TIP: When installing this product wear protective gloves and eyewear.

DISCLAIMER: Please refer to the building department in your local council in regards to the building standards and regulations for use of this product.


  1. Measure the vertical wire spacing on all posts, drill a 10.5mm hole for all end posts and 5mm holes for mid posts.
  2. Insert the cylindrical hex head tensioner through the end post with a washer either side of the post. Then screw the threaded terminal into the hex head tensioner.
  3. Loosen the cone head until the hole in the thread is visible. Push the wire rope through the front of the cone head until it is visible through the hole in the thread.
  4. Tighten the cone head using a spanner.
  5. Pass the wire through the centre posts to the end post and cut wire to size.
  6. Repeat step 2 & 3.
  7. To tension the wire, use a spanner to turn the cone head terminal until the wire is at its required tension. Use a spanner to tighten the lock nut onto the cylindrical hex head tensioner so it does not loosen.





Next Day Delivery